![]() However, our directory is accessible to anyone and everybody can edit and delete files at will, which is not recommended especially if you plan to host sensitive files. We have successfully managed to access our s amba share. Now, we will navigate to the ‘ Public‘ folder where the files we created earlier will be displayed. So, we will head back to our terminal and create a few files in the samba share directory. ![]() Access Samba Share Directory on WindowsĬurrently, our directory is empty as we have not created any files. Remember, this is the directory that points to our samba share in the /srv/tecmint/data directory. The following window labeled ‘ Public’ will pop up. In the textfield provided, enter the samba server’s IP address as shown: \\server-ip To do this on a Windows client, press the Windows logo key + R to launch the Run dialog. Thus far, we have installed samba and configured our samba share. Step 3: Accessing Samba Share from Windows $ sudo firewall-cmd -permanent -add-service=samba To enable access to samba share from remote Windows systems, you need to open the samba protocol on the firewall. ![]() $ sudo systemctl start smbīe sure to confirm that both the smb and nmb daemons are running. Next, start and enable Samba daemons as shown. To verify the configurations made, run the command: $ sudo testparm We will define policies on who can access the samba share by adding the lines shown in the configuration file. Next, we are going to create a new configuration file. $ sudo mv /etc/samba/smb.conf /etc/samba/ But before we do so, we will back up the file by renaming it with a different file extension. Next, we are going to make some configurations in the smb.conf configuration file which is Samba’s main configuration file. $ sudo chcon -t samba_share_t /srv/tecmint/data $ sudo chown -R nobody:nobody /srv/tecmint/data ![]() Next, we will assign permissions and ownership as follows. Here, we are going to create a samba share called /data in the /srv/tecmint/ directory path. A samba share is simply a directory that is going to be shared across client systems in the network. Once all the samba packages have been installed, the next step is to configure the samba shares. Samba Installation Completes Step 2: Create and Configure Samba Shares After the installation is complete, you will get a summary of all the packages that have been installed. The command installs the packages specified along with the dependencies as displayed on the output. To get started out with Samba, install the Samba core packages including the client package: $ sudo dnf install samba samba-common samba-client In this guide, we will walk you through the installation of the Samba Server on RHEL-based distributions such as CentOS Stream, Rocky Linux, and AlmaLinux. The software is installed on a central Linux server from which shared files can be accessed from both Linux and Windows systems. Samba, a re-implementation of the popular SMB ( server message block) protocol, is a stable and free application that allows sharing of files and print services across a network. One of the widely used file-sharing software is Samba. It allows sharing of resources across the network which are needed by users to carry out their tasks. Sharing files is an essential part of server administration.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |